Avallon APAC120S User's Guide download pdf (Page 16)

Operating the Remote Control

Use the Power button to turn the portable air conditioner on and off.

By default when you first use the power button, the unit will begin to

operate in cooling mode and the front panel will be illuminated in blue.

The unit will remember the last used mode/settings if you shut down and

restart.

Auto-Restart: If power to the unit is interrupted, the air conditioner will

restart itself in its last used mode/settings once power is restored. The

compressor will restart after 3 minutes.

Cooling mode cools and dehumidifies the air. If the ambient temperature

drops below the temperature you selected, the compressor turns off and

the unit functions with the fan only. When the temperature rises above the

temperature you selected, the compressor turns on again. The front panel

lights will be blue. Whether your desired temperature can actually be

reached depends on the ambient conditions. The room temperature

remaining above the set temperature is normal.

To operate the unit in cooling mode:

1) Make sure the power cord is plugged into a power outlet.

2) Press the Power button on the remote control.

3) Press the Mode button until the cooling indicator is selected.

4) Select the fan speed by using the Speed button.

5) Set the thermostat by using the Up and Down buttons. The

thermostat is adjustable between 64°F - 90°F in one degree increments.

You can switch between Fahrenheit and Celsius by pressing the

button.

During the Dehumidifying mode, the unit will condense water out of the air

and exhaust it through the exhaust hose. The ambient temperature in the

room will probably drop by a few degrees while using the Dehumidifying

mode. The front panel lights will be yellow.

To operate the unit in dehumidifying mode:

1) Make sure the power cord is plugged into a power outlet.

2) Press the Power button on the remote control.

3) Press the Mode button until the dehumidify indicator is

selected.

This mode allows the units to run as a heat pump. The unit must be

vented for it to expel the cold air out the exhaust.

To operate the unit in heat mode:

1) Press the Mode button until the heat indicator is selected.

2) Set the thermostat by using the Up and Down buttons.

Power

Cooling Mode

Dehumidifying Mode

Heat Mode

NOTE: The exhaust hose

must be used in Cooling

mode in order to cool a room.

NOTES: If the room temperature is below 77ºF, the fan will always run on low speed in this mode. If you do

not use the exhaust hose in Dehumidify mode, you must manually drain the water from the unit.

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 24 25

Comments to this Manuals

No comments

Avallon APAC120S User's Guide Page 16

Comments to this Manuals

Related products and manuals for Mobile air conditioners Avallon APAC120S